Difference between revisions of "Mechatronic"
From emboxit
m (1 revision) |
|
(No difference)
| |
Revision as of 16:51, 11 September 2015
- GRBL Standalone Arduino-based GCODE to 3 X step-motors
- TI Microstepping DRV88xx and MSP430
- Mechatronic-systems Low cost pp systems including offer
- RedFrog Pick & Place DIY pp plywood kit
- Smoothie Project opensource, high performance G-code interpreter in C++ for the LPC17xx micro-controller
- It will run on:
- mBed
- LPCXpresso
- SmoothieBoard
- 4pi
- R2C2
- Or any other LPC17xx or SAM3U based board.
- The motion control part is a port of the awesome GRBL
